Same Day Shipping SHARP SHOOT R MAXX MIL- SPEC LUBRICANT 8oz BOTTLE

Maxx Is the New Mil-Spec Lubricant for the U.S.Military in a CONVENIENT 8 ounce squeeze bottle. Maxximum Lubrication Maxximum Corrosion Protection Maxximum Moisture Protection Maxximum Reduction of Friction Military Small ArmsMIL_PRF_32033 How it works: Maxxis a cutting edge product. It contains a patented particulant contained in no other commercial lubricants. This use of this particulant is protected by a patent. One of the smallest particulants used in lubricants is molybdenum. The particulant in molybdenum is approximately 2 microns in diameter. Maxx contains a patented particulant that is spherical in structure, and is less than 1/20 th of a micron in diameter. The minute size of this particulant greatly decreases friction and drag by reducing greatly the build_up of heat. It puts an ultra_thin layer of spherical particulant and a high heat tolerant lubricant between metal parts. The small diameter of this particulant allows Maxx to penetrate in to the terrain of metal surfaces, which are less than 1/20 th of a micron deep. This particulant further carries with it a unique blend of synthetic non_petroleum low drag lubricant and high lubricity natural oils that sets up a boundary shield of lubrication. Shooters and outdoorsmen have problems unique to their particular sport. Firearms encounter explosive heat, grit, sand, corrosion, unburned powder residue, primer residue, carbon, minute metal fragments, and moisture as a routine part of normal use. Firearms also need to have long-term protection from rust and corrosion, as well as adequate lubrication. Properties: The characteristics of this natural/synthetic blend lubricant are quite unique, in that they have an operating range of +600º F down to -70º F. Being a synthetic base lubricant, Maxx is non-gumming, and non-shellacing over any length of time. It does not change in viscosity or color, over time. Maxx contains no teflon or PTFE of any kind. These products have proven themselves to be gumming agents a which build up, and actually prevent lubrication to take place. How to use Maxx : Maxx works in a truly unique manner. It is applied in two or three applications after a thorough degreasing solvent is used. It is necessary to remove all evidence of other lubricants to make Maxx totally effective. Apply Maxx to a clean firearm and allow the volatiles to vaporize for 5 minutes or so. Apply a second application and repeat the drying procedure. This allows Maxx to build a coating over the metal of around 20 to 25 microns in thickness. It is this film that provides maximum lubrication while cutting friction to an absolute minimum. Maxx has proven itself superior in all the testing done by the U.S. Military and has been adopted as the lubricant for all small arms both semi-automatic and fully automatic. Maxx has a neutral di-electric constant which allows the product to lubricate without attracting dirt and grit. Most lubricants are either positive or negative charged which is an attractant to dust particles. The neutral di-electric constant properties also allow Maxx to be used in any application where electric polarity is a concern. Maxx is also a boon to users because if its moisture displacing qualities. Maxx will force moisture out of any metal or electrical parts and provide both lubrication and corrosion protection. Maxx proved itself a superior anti-corrosion product in the testing done by the U.S. Military. A film of Maxx was put on metal parts to be tested, then a 5% solution of salt spray coated the test parts and the temperature was raised to 95 degrees. Maxx coated parts went for over 1000 hours with no rust or corrosion.